Skip to main content

Managing Banners

From the Banner page, administrators can upload a text file for the Advisory and Consent Banner. The banner is typically an advisory/warning notice to be displayed before the Sign-in page.

Only ASCII file format is supported for the banner file; the banner is a single text file with a maximum file size of 4KB.

To upload a text file for the Banner page:

  1. Click Security on the sidebar, and select the Banner tab. 
    The Banner page opens. If banner text has been imported, it will be displayed here.
  2. Toggle Enable Sign-In Banner on to display the Advisory Notice and Consent Banner upon user sign-in.

  3. Click Browse and select the file in the Open File dialog box. 
    The banner filename is now displayed on the Upload Banner task bar.


    Tip

    To select a different banner file, click Cancel.

  4. Click Upload. The banner text is now displayed in the pane. 

    Note

    When the banner is enabled, the time when the banner actually gets displayed may vary with the service in use (such as SSH, Telnet, serial port, or Web interface) and how the services are configured. For example, in some cases, the banner will be displayed right after the sign-in and before the password is entered, whereas with the Web interface, the banner will be displayed before the user gets to the Sign-in page.

    Important

    IP display is enabled on the serial port login prompt by default and takes precedence over a banner. If both Banner and IP display are enabled, users will see the IP, not the banner on the serial port.
    You can disable and re-enable IP display using the CLI commands disable_ip_display_on_serial_port and enable_ip_display_on_serial_port. If you disable IP display with this CLI command, the banner works.

  5. To apply your changes, click Apply.

  6. To delete the current banner click Delete. A pop-up message will appear:
     


    If you are sure you wish to delete the banner message, click Delete again.

    Tip

    You can also install and manage banner files from the CLI using the banner command. The Makito X supports FTP and TFTP client, as well as SCP client and server.

Related Topics

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.