Skip to main content

CLI Command Reference

Management via the CLI is possible through a telnet session or SSH. This alphabetical command reference lists and describes the available Command Line Interface (CLI) commands to configure and manage the Makito X decoder.

Accessing the CLI

To access the decoder CLI:

  1. Open a telnet session to the decoder (for the default encoder IP address, see Accessing the Decoder).

  2. At the login prompt, type the username and password (see Role-based Authorization).

Topics and Commands Discussed

Syntax Conventions
Command Summary and Access Control
Operation Commands
Network and Management Commands
Security Commands

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close