All field units that you are using as sources have Hub 360 set as a destination profile, and all Makito devices are paired to Hub 360. See Adding an Appliance for more details.
The StreamHub used for the route is registered in the Hub 360 fleet.
All nodes (encoders and IP output profiles) have been previously defined on the StreamHub application, else they do not appear in Hub 360. You can refer to the Configuring Encoder Profiles and Configuring IP Output Profiles topics in the StreamHub User Guide.
In the Routes pane, click the Receivers dropdown menu to select the receiver you want to use for the new route.
To use a source for the route, you can either:
Drag and Drop
Drag and drop the source tile from the Sources pane to the Routes pane.
Tip
If a route cannot be created when dragging the source tile, the reason is listed on the route:
Select from Dropdown
Select a source from the drop-down list on a route tile.
Tip
When you hover over sources that cannot be selected, a tooltip appears showing the reason.
After you have added your source, it is time to add the encodes and outputs. You can either:
Click the Options icon in the top right corner of the desired receiver tile and select the Edit icon.
(StreamHub only) Click the Expand icon the desired receiver tile. After the detailed tile view appears, click the Edit icon.
In the Settings panel, edit the Route Name as desired.
On the sidebar, click the Nodes (StreamHub) or Outputs (Makito Decoder) tab.
On this tab, drag and drop the desired nodes onto the route map and make the desired connections between the tile nodes. See Working with Routes for how to accomplish these tasks.
When finished designing your route, click the Save button.
JavaScript errors detected
Please note, these errors can depend on your browser setup.
If this problem persists, please contact our support.
