Skip to main content

Step 8: Verification and Reboot

To complete the hardening procedure, you should run through the checklist in Appendix A (see Appendix A: Hardening Checklist). 

If all has been properly configured, reboot the Makito X Series. This will take approximately 5 minutes.
On reboot, a self-test is automatically started.

If the self-test completes with no errors, and if all items in the checklist (including post-reboot items) have been verified, then you have successfully brought the encoder or decoder to its hardened state.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.