Skip to main content

Compliance

Before using the unit, please inform yourself about laws and regulations in force in the country in which you use it. Please refer to the sticker pasted on the unit to know its version.

The declaration of conformity is available upon request. Should you need it, please contact Haivision.

Federal Communications Commission Statement

Model: Pro360-5G

Contains FCC ID: 2ASIK-EM91

Contains FCC ID: 2ASIK-CB178NF
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.


Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device must be professionally installed

The Company “HAIVISION” is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.
This portable equipment with its antenna complies with FCC’s radiation exposure limits set forth for an uncontrolled environment. This equipment has shown compliance with FCC’s Specific Absorption Rate (SAR) limits. To maintain compliance, follow the instructions below:

  1. This transmitter must not be co-located or operating with any other antenna or transmitter;
  2. A minimum distance of 15 mm between the user and the antenna must be kept in order to comply with FCC SAR requirement.

Industry Canada statement

Model: Pro360-5G

CAN ICES-3 (B)/NMB-3 (B)

Contains IC: 21415-EM91

Contains IC: 21415-CB178NF
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.


L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

  1. L’appareil ne doit pas produire de brouillage;
  2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.


This portable equipment with its antenna complies with RSS102’s radiation exposure limits set forth for an uncontrolled environment. This equipment has shown compliance with RSS102’s Specific Absorption Rate (SAR) limits. To maintain compliance, follow the instructions below :

  1. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
  2. A minimum distance of 15 mm between the user and the antenna must be kept in order to comply with IC SAR requirement.


Cet équipement portable avec ses antennes est conforme aux limites d’expositions de la CNR102 applicables pour un environnement non contrôlé. Cet équipement a démontré la conformité aux limites de Débit d’Absorption Spécifique (DAS). Pour maintenir la conformité suivez les instructions ci-dessous:

  1. Cet émetteur ne doit pas être co-localisé ou opérer en conjonction avec toute autre antenne ou émetteur.
  2. Une distance minimale de 15 mm entre l'utilisateur et l'antenne doit être respectée afin de se conformer à l'exigence SAR de IC.

WI-FI 5GHz

Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.

La bande 5150-5 250 MHz est réservée uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.