Services Settings

The configurable Services are as follows:

Network Services

Service	Description
HTTP	Hypertext Transfer Protocol, used for Web browsers acting as a client. Note Only secured HTTP (HTTPS) is supported. See Managing Certificates (Encoder) or Managing Certificates (Decoder) to manage HTTP TLS certificates.
SSH	Secure Shell, a network protocol that allows data to be exchanged using a secure channel between two networked devices.
Telnet	Telnet, a network protocol used on the Internet or local area networks to provide bidirectional communications via a virtual terminal connection.
SNMP	Simple Network Management Protocol, a network protocol used mostly in network management systems to monitor network attached devices.
Haivision EMS	EMS (Element Management System) allows simple management of Haivision-only devices such as Haivision EMS and Haivision Hub 360. For more on pairing to EMS, see. For more on pairing to Hub 360, see Adding an Appliance in the Haivision Hub 360 documentation.

Encoder-specific

Service	Description
VF	Protocol used for communication between the encoder and Furnace servers. Note that VF Pilot provides access to encoder configuration settings.
Talkback	Audio Talkback (a Makito X feature) allows end users monitoring a streaming session to "talk back" to individuals at the video source, via a speaker or headphones connected to the encoder. For details, see Audio Talkback.
Serial Pass- Through	Bi-directional serial pass-through for controlling serially attached devices such as PTZ controlled cameras. Both RS-232 and RS422 are supported. Note The COM Port Mode must first be set to Pass-Through (see Managing the COM Port).
Port	(Serial Pass-Through must be enabled) Specifies the TCP port that the Makito X will listen on for remote commands.
RTSP	Enables streaming of video feeds from the Makito X encoder to a Milestone server for archiving and analysis using the RTSP protocol.
ONVIF	Enables the ONVIF management API to send commands from the Milestone XProtect video management software (VMS) to the Makito X encoder.

Decoder-specific

Service	Description
SAP	Session Announcement Protocol, used to populate the device’s Streams table with streams advertised via the SAP protocol.
Talkback	Audio Talkback (a Makito X feature) allows end users monitoring a streaming session to “talk back” to individuals at the video source (encoder), via a microphone connected to the decoder. For details, see Audio Talkback.
SAP Settings
IPv4 Listening Address	Specifies the multicast IPv4 address on which the SAP service will listen (as defined in RFC 2974). Note The Makito X decoder listens for SAP on three different addresses when Automatic is selected: 224.2.127.254 (IPv4 global scope announcement multicast address) 239.255.255.255 (IPv4 local scope announcement multicast address) 239.195.255.255 (IPv4 organization local scope announcement multicast address) The standard IP addresses and ports for multicast SAP announcements are defined in RFC 2974.
IPv6 Listening Address	Specifies the multicast IPv6 address on which the SAP service will listen (as defined in RFC 2974). Note The Makito X decoder listens to `FF0X::2:7FFE` where X is the 4-bit scope value.
Port	Specifies the UDP port on which the SAP service will listen.
Talkback Settings
Port	Specifies the destination port used by the encoder. Default = 9177.
Button Mode	Specifies whether the Web interface provides a push button or toggle switch for users to activate talkback. Push Button provides “push-to-talk” functionality, which requires that users push a button to transmit audio and keep pushing the button to use the talkback channel. This prevents a user from accidentally locking and not releasing the channel. Toggle Switch stays active until the user pushes it again.