Skip to main content

Analog Audio Settings

The following table lists the decoder analog audio controls and settings:

Input
SettingDefaultDescription/Values
SourceSDI 1

The input source for analog audio, either:

  • SDI 1
  • SDI 2

Note

When the decoder is licensed for one channel only, the SDI2 option is not available. The content on SDI2 mirrors the content from the SDI1 interface.
Channels1&2

The input channel for analog audio, either:

  • 1&2
  • 3&4
  • 5&6
  • 7&8

Note

When the decoder is licensed for one channel only, the channel pairs 9&10, 11&12, 13&14, and 15&16 are also available.
Basic Parameters
SettingDefaultDescription/Values
0 dBFS Audio Level (dBu)+6 dbu

(Analog Input only) Adjusts the maximum analog Audio Output level (0 dBfs) from +5dBu up to +20dBu.

Note

This is useful in applications such as broadcast and streaming to allow higher audio headroom.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.