Skip to main content

personality

Note

If you downgrade to a pre-1.4 release, do not use the personality command. Although it is available (it was in place as a test feature), it requires release 1.4 or later to run properly, and you risk your encoder ending up in a reboot loop.

The personality command is used to manage the Makito X4 Encoder personality, to switch between SDI, SQD, and SMPTE ST 2110. For the latter, an SMPTE ST 2110 license must be installed. This setting will take effect upon the next reboot. For details, see Configuring ST 2110 Inputs and Configuring SQD Inputs.

Synopsis

personality set TYPE
personality get

Actions

ActionDescription

set

Sets the personality that will take effect on the next reboot.

get

Displays the current personality.

Parameters

ParameterDefaultDescription/Values
TYPE

SDI

Switches between SDI, SQD and SMPTE 2110 input. This setting will take effect upon the next reboot. SDI, SQD, or 2110.

Examples

# personality set SDI

Returns the following confirmation:

Personality updated successfully.
A REBOOT is required for the new personality to take effect.
# personality get

Returns the current personality:

Current Personality     : 2110



JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.