Skip to main content

CLI Command Reference

Management via the CLI is possible through a telnet session, SSH, or RS-232 (Makito X4 Rugged only). This alphabetical command reference lists and describes the available Command Line Interface (CLI) commands to configure and manage the Makito X4 encoder.

Accessing the CLI

To access the encoder CLI:

  1. Open a telnet session to the encoder (for the default encoder IP address, see Default Encoder IP Address).
  2. At the login prompt, type the username and password (see Role-based Authorization).

Topics Discussed

Syntax Conventions
Command Summary and Access Control
Operation Commands
Administration Commands


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close