Stream Settings
The following table lists the stream controls and settings:
| Stream Setting | Default | Description/Values |
|---|---|---|
| Name | N/A | Specify a name for the stream. 1 to 32 characters |
| Protocol | TS over UDP | Select the Encapsulation Protocol type for the decoded stream.
|
| Type | Unicast | (TS over UDP and TS over RTP only) Select the Stream Type for the decoded stream.
|
| Multicast Address | N/A | (Multicast streams only) Enter the multicast IP address in dotted-decimal format. |
| Source Address | N/A | (Multicast streams only) The Source Address specifies where the multicast stream is coming from (i.e., what address is broadcasting). In cases where many devices are sending multicast streams on the same multicast address, specifying the source encoder address can reduce the amount of multicast traffic being forwarded on your network. Only the multicast traffic from that specific source to that address will be forwarded (instead of all of them). |
| Address | N/A | (TS over SRT only) Enter the source IP address in dotted-decimal format. |
| Port | N/A | Enter the source UDP port for the stream. Enter a number in the range 1025..65,535. Note that RTP streams use even numbers only within this range. |
| FEC | None | (Optional, TS over RTP only) Enable Forward Error Correction (FEC). Select either:
On the Encoder, you set all these parameters, whereas on the decoder they are detected from the stream, and are available in the stream stats. |
Related Topics