Skip to main content

_reboot_CLI MK4 cmd

The reboot command is used to turn off and restart Makito X devices. Any unsaved configurations will be lost. The unit will restart with the saved startup configuration.


The reboot command can only be used by an administrator.




# reboot

Reboots the Makito X.                                                                                                                          


While the unit is rebooting, you will lose your connection to the CLI. This will take approximately two minutes. Once the unit has rebooted, you can reconnect to the unit and sign in again.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.