_leds_CLI MK1 cmd

The leds set mode command may be used to control the behavior of the Status LED at startup.

If normal mode is used (default), the Status LED will blink for a short while when booting and will become solid green and remain that way once the system is fully
operational.
If timeout mode is used, the Status LED will blink for a short while when booting and will become solid green for a specified amount of time in seconds before
going off.
The duration of time for which the LED remains lighted up can range from 5 to 3600 seconds.
When mode is set to off, the Status LED never lights up.

leds get
leds set mode=off,normal,timeout [duration=10]

Action	Description
set	Configures LED parameters. A series of one or more `parameter=value` pairs can be specified at once. See Parameters below.
get	Displays LED status information for the Makito X1.

Parameter	Default	Description
`duration`	n/a	The blinking duration can be set from 5 to 3600 seconds (60 minutes). If no duration is set, blinking will last for 10 minutes.

# leds set mode=normal [duration=10]

Sets the Status led to blink for 10 seconds while when booting and to become solid green and remain that way once the system is fully
operational.

# leds get

Displays current LED status for the encoder (blinking initiated above):

LED States:
Status : Green
Mode : Normal