_ipv6config_CLI cmd
The ipv6config command is used to view and set the parameters that specify the IPv6 network configuration of Makito X Series devices.
As shown in the examples that follow, when you enter the ipv6config configure command, the system displays the current IPv6 settings and takes you through a series of prompts enabling you to change these settings. You can either assign a static IPv6 address or use DHCPv6 (Dynamic Host Configuration Protocol for IPv6).
You must reboot for any changes to take effect.
Synopsis
ipv6config display |
Actions
Action | Description |
|---|---|
display | Displays the current IPv6 configuration. |
configure | Configures IPv6 settings. |
disable | Disables IPv6 functionality. Note You cannot disable IPv6 if IPv4 is already disabled. |
Parameters
N/A