Skip to main content

Installing the Unit

  1. Connect the Protective ground terminal.


    The Protective ground terminal must be connected to the RACK ground pin. This pin must be connected to the safety ground.
  2. Connect the AC/DC adapter and the power cable.

  3. Insert the SD card (if not already installed).


    It is recommended to use FAT 32 or exFAT formats and class 10 SD card.

  4. For Ethernet transmission, connect the Ethernet cable to Ethernet (ETH) 1.


    DHCP is the default operating mode for Ethernet 1.

  5. Connect the video input cables (SDI or HDMI).

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.