Skip to main content

Configuring IP Routes

According to your network architecture; you may need to configure IP routes on the server. To configure an IP route:

  1. Press the number corresponding to IP Settings menu.



  2. Press T on your keyboard to access the Route table page.
  3. Press A on your keyboard to add a new route.
  4. According to the type of destination for which you want to add a route:
    • Press 1 on your keyboard to configure a network route (net).
    • Press 2 on your keyboard to configure a host route (host).
  5. Type the destination IP address.



  6. If the destination is a network, type the netmask.
  7. Type the gateway (that must be on the same LAN as the server).
  8. Press 1 or 2 on your keyboard to select the Ethernet interface for which you want to set this route.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.