Installing the Encoder

This section explains how to set up and connect the Makito X encoder. It also includes the instructions for a factory reset and hardware maintenance.

Note

For instructions on installing the Makito X ruggedized or harsh encoders, please refer to the following documents (available on the Haivision InfoCenter):

For the steps to install the MB6 or MB21 chassis, please refer to the MB Chassis Installation Guides.

Topics Discussed

Setting Up the Encoder

Connecting the Encoder to the Network and a Computer

Serial Interface Setup (Makito X SDI)

Connecting the Encoder to A/V Sources

Powering Up the Unit

Resetting the Encoder

Hardware Maintenance