Skip to main content

Connecting to the Network

To connect the Network Interface

  1. Connect the Makito X’s network port to the IP network using an Ethernet UTP cable (type Cat 5 or higher).

    Network and COM1 Ports (Makito X SDI, #S-292E-HDSDI2)

  2. You can now telnet to the unit or connect via the Web interface.

Note

To connect the serial interface (if applicable, SDI only), please refer to Serial Interface Setup (Makito X SDI) in the User's Guide.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.