Skip to main content

CLI Command Reference

Management via the CLI is possible through a telnet session, SSH, or (if applicable) RS-232. This alphabetical command reference lists and describes the available Command Line Interface (CLI) commands to configure and manage the Makito X encoder.

Accessing the CLI

To access the encoder CLI:

  1. Open a telnet session to the encoder (for the default encoder IP address, see Accessing the Encoder).
  2. At the login prompt, type the username and password (see Role-based Authorization).
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.