Audit Settings
The following table lists the Audit controls and settings:
Setting Default Description Enable Audit disabled Check or clear this checkbox to enable or disable audits for the system. Audit Server Address n/a Type in the address and port of the remote server, in one of the following formats: If the port is not provided, the default port for the chosen Transport will be used: Transport UDP Select the Transport Type from the drop-down list: UDP (default port: 514) TLS (Transport Layer Security, default port: 6514) Trusted Servers ALL (TLS must be selected for Transport) Select the type of certificate exchange: All: Server authentication is disabled. Any server that is set in the Audit Server Address field will be accepted as a trusted server, and the authentication step is skipped. CA-signed: Enables server authentication during the startup of an audit. The encoder will only accept a connection with the specified audit server if the certificate it presents is signed by a trusted Certificate Authority (i.e., The certificate of that certificate authority is present in the Makito X's CA Certificates list). Self-signed: Enables server authentication. A connection with the specified audit server will be accepted if its certificate is self-signed, and its fingerprint matches the one configured on the Makito X. Fingerprint n/a (Only appears if Self-signed is selected for Trusted Servers) Enter the fingerprint of the audit server’s self-signed certificate. The fingerprint should be the SHA-1 or MD5 fingerprint of the certificate that belongs to the audit server which was set in Audit Server Address.fqdn[:port]ipv4_addr[:port]ipv6_addr[:port]hostname[:port]