Skip to main content

Physical Characteristics

The table below describes some basic characteristics of the Makito X4 Rugged Encoder. For complete specifications, please refer to the data sheet available from the Haivision Web site.

Makito X4 Rugged Encoder (#S-MX4E-R-SDI4-ISR)

Dimensions

66mm H x 146.2mm W x 185.7mm D
(2.675" H x 5.755" W x 7.31" D)

Weight

1.93 kg (4.25 1bs.)

MaterialAluminum 6061 T651 per SAE AMS-QQ-A-250/11 
FinishExternal: Black anodized, as per MIL-A-8625F, Type 2, Class 2 

Power

28 VDC Nominal, 25W

Temperature

Operating: -40°C to 71°C (-40°F to 160°F)
Non-operating: -45°C to 85°C (-49°F to 185°F)

Relative Humidity

0-100% condensing

IP rating

IP67
Dust tight with water immersion up to 1 meter depth for 30 minutes.

Caution

The IP67 rating only applies when the connectors are mated.
Otherwise, the usage of dust cap connectors (provided by Haivision, shown in the following figures) is required.


Note

Hirose cabling assembly must be done using the Hirose LF Series Connector Termination and Assembly Instructions.

If the mating cable assemblies are not provided by Haivision, please make sure to meet Hirose’s specifications and recommendations, especially in relation to waterproofing. Failure to meet Hirose’s specifications may void the product warranty.


Caution

If you have questions regarding the suitability of the Makito X4 Rugged encoder in your operating environment, please contact Haivision Technical Support.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.