Skip to main content

Physical Characteristics

The table below describes some basic characteristics of the Makito X4 Rugged Encoder. For complete specifications, please refer to the data sheet available from the Haivision Web site.

Makito X4 Rugged Encoder (#S-MX4E-R-SDI4-ISR)


66mm H x 146.2mm W x 185.7mm D
(2.675" H x 5.755" W x 7.31" D)


1.93 kg (4.25 1bs.)

MaterialAluminum 6061 T651 per SAE AMS-QQ-A-250/11 
FinishExternal: Black anodized, as per MIL-A-8625F, Type 2, Class 2 


28 VDC Nominal, 25W


Operating: -40°C to 71°C (-40°F to 160°F)
Non-operating: -45°C to 85°C (-49°F to 185°F)

Relative Humidity

0-100% condensing

IP rating

Dust tight with water immersion up to 1 meter depth for 30 minutes.


The IP67 rating only applies when the connectors are mated.
Otherwise the usage of dust cap connectors (provided by Haivision, shown in the following figures) is required.


If you have questions regarding the suitability of the Makito X4 Rugged encoder in your operating environment, please contact Haivision Technical Support.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.