Status Settings
The following table lists the Status settings. Status information can be useful for troubleshooting and may be forwarded to Haivision Technical Support if you are requesting technical support.
Status Setting | Description/Values |
|---|---|
| Personality | (Makito X4 non-rugged Encoder only, with SMPTE 2110 license installed) Select between SDI, SQD (version 1.6 and later), and SMPTE 2110 input. This setting will take effect upon the next reboot. |
Card Status | OK (or error message if applicable). |
Card Type | The type of device, e.g., Makito X4 SDI Encoder. |
Part Number | The Haivision part number for the encoder or decoder, e.g., B-MX4E-SDI4 or S-MX4D-SDI. |
Serial Number | The serial number for this appliance or card. |
Firmware Version | The firmware version of the device, e.g., 1.0.0-23. |
Firmware Date | The firmware release date. |
Hardware Version | The hardware version of the device. |
Hardware Compatibility | -001G or -002G (basic card assembly). |
| Carrier Type | (Makito X4 Rugged Encoder only) The interface carrier board. Note In Release 1.2, the number of CVBS inputs supported depends on the Carrier Type. "Makito 4KR" indicates the three-input variant, whereas "Makito 4KR 12G" indicates the four-input variant. |
CPLD Version | The CPLD version of the device. |
Boot Version | The Boot version of the device. |
System Uptime | The length of time the encoder or decoder has been "up" and running (e.g., 4 days 17:42:03). |
Encoding Chipset Load | (Encoder only) The combined video encoding processor usage in percentage% (combining both Hi and Lo streams). |
| Temperature | The current board temperature in degrees Celsius. |
