Logo Settings

Input

N/A

Logo inputs correspond to the available video inputs of your Makito device.

Position

Bottom Right

Select the position for the logo overlay:

• Bottom Right

• Top Right

• Bottom Left

• Top Left

• Centered

• Absolute

Note

In Absolute mode, the logo will be positioned at the exact X and Y coordinates specified.

• Relative

Note

Relative mode uses the X and Y coordinates specified, while keeping the logo position in proportion to the display area, regardless of the input resolution. The original scaling is vis-à-vis a 1920x1080 grid.

Coordinates

0, 0

Specifies the position of the logo on the X and Y axes. (The origin is the top left corner of the display area.)

Note

Only takes effect if Position is set to Absolute.

Scaling

100

Specifies the scale factor (percentage) for the logo:

• 25% = 1/4 size

• 100% = no scaling

• 400% = 4x

Opacity

100

Specifies the opacity percentage of the logo:

• 0 = no opacity (i.e., a completely transparent logo) 

• 100 = fully opaque (i.e., a completely solid logo)

Use relative scaling

Disabled

Check this check box to enable relative scaling. Relative scaling keeps the logo's dimensions constant in relation to the display area, regardless of the input resolution.
The original scaling for the logo size is vis-à-vis a 1920x1080 grid. 

Enable/Disable

Enabled (after configuration)

Toggle the logo configuration on or off to enable or disable its display.