Skip to main content

COM Port Settings

The following table lists the COM Port settings.

Note

With the exception of the COM Port Mode, the COM Port settings are read-only. For information on modifying the COM Port settings, see "Metadata Settings" (link below).

COM Port Setting

Default

Description/Values

Mode

Management

Selects the type of activity:

  • Management
  • Metadata (required in order to configure the Metadata settings)
  • Pass-Through (required to control serially attached devices such as PTZ controlled cameras).

Note

You must reboot the encoder when you change the Mode.

Standard

RS-232

(Read-only) The serial mode standard:

  • RS-232 or
  • RS-422

Baud Rate

115200

(Read-only) The COM Port bitrate.

Data Bits

8

(Read-only) The COM Port databits: 8

Parity

None

(Read-only) The COM Port parity: None

Stop Bits

1

(Read-only) The COM Port stopbits: 1

Flow Control

None

(Read-only) The COM Port flow control: None

Related Topics:


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.