Skip to main content

Ad Insertion Settings

ParameterDefaultDescription/Values

Name

n/a

A unique descriptive name of up to 63 characters. 'none' can be used to revert to the default name.

Pre-Event Reminders

3

Number of event reminders to send to downstream equipment. Range from 1 to 5.

Message Delta

2000 (without parameters)

Interval (in milliseconds) between event reminders. Range from 100 to 10,000ms (with parameters).

Synchronization

Auto

Options are:

Auto - Auto-select the sync mode based on what SCTE-104 messages are being received. The priority of selected sync methods is as follows (in decreasing order): Alive, Time, System.

Alive - Force the use of the received SCTE-104 alive_request_data() messages as the means to synchronize the time between the upstream SCTE-104 source and the Makito.

Time Descriptor - Force the use of the received SCTE-104 insert_time_descriptor() messages as the means to synchronize the time between the upstream SCTE-104 source and the Makito.

System - Use the local system time as the means to synchronize the time between the upstream SCTE-104 source and the Makito. NTP should be configured as the local time source.

Note

These modes only apply when time deferred SCTE-104 requests are requested from upstream SCTE-104 sources.

Leap Seconds

37

Leap seconds added since Jan 1, 1958 to convert UTC to TAI.

Time Descriptor Period

0 (disabled)

Period (in seconds) to force the insertion of time_descriptor. Range from 0 (disabled) to 60.

 

Note

You can also configure the Ad Insertion settings from the Command Line Interface (CLI). See adinsertion.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.