Creating a Route

Prerequisites

Before you create a route, ensure the following:

All field units that you are using as sources have Hub 360 set as a destination profile, and all Makito devices are paired to Hub 360. See Adding an Appliance for more details.
The StreamHub used for the route is registered in the Hub 360 fleet.
All nodes (encoders and IP output profiles) have been previously defined on the StreamHub application, else they do not appear in Hub 360. You can refer to the Configuring Encoder Profiles and Configuring IP Output Profiles topics in the StreamHub User Guide.

Tip

To create a route:

Click Master Control on the sidebar.
In the Routes pane, click the Receivers
dropdown menu to select the receiver you want to use for the new route.
To use a source for the route, you can either:
Drag and Drop
Drag and drop the source tile from the Sources pane to the Routes pane.

Tip

If a route cannot be created when dragging the source tile, the reason is listed on the route:

Select from Dropdown
Select a source from the drop-down list on a route tile.

Tip

When you hover over sources that cannot be selected, a tooltip appears showing the reason.
For Makito devices, the route is created and the stream starts.
For StreamHub devices, after you have added your source and if the route has yet to be configured, a Route Configuration modal appears for you to select the outputs you would like to use for your stream.
1. Click the Output dropdown, and select an available output.
  
  Tip
  
  If no outputs appear, you must create the IP output profiles first on your StreamHub. Click the Configure Later button, reference Configuring IP Output Profiles topic in the StreamHub User Guide to add the profiles, and Editing a Route and Working with Routes to update your route.
2. To add multiple outputs to the route, click the Add button and select another available output.
3. Click the Save button.
4. The route is created and the stream starts.