Skip to main content

Release Notes 2.3.0

Haivision Hub Release 2.3.0 Update

Component Versions

  • Hub: 2.3.0
  • Hub API: 2.2.0


This latest release to Haivison Hub focuses on security and stability improvements with route provisioning / de-provisioning, loading experience. Along with bug fixes and stabilization, we removed deprecated Hub API endpoints.


What's New

  • General availability of Appliance Management functionality
  • General availability of Audio Manipulation hublet. 
  • Improvements to the Hub telemetry/statistics panel when a route is running.
  • Improvements to the Usage (aka Billing) section under the Admin Area.
  • Renamed Billing section to Usage under the Admin Area.
  • Removed deprecated Hub API endpoints.
  • Enhancements to prevent route provisioning/de-provisioning errors.
  • Bug fixing and stabilization.

Known Limitations

  • When changing Hub roles/permissions, it may take up to 5 seconds to be refreshed in the Hub Portal (or just force a page refresh in the browser).
  • Hub users with multiple identity provider that uses the same email, may experience a conflict with permissions / roles.
  • Agile outputs are disabled for appliance-to-appliance direct routes.
  • Only a single input hublet per route is allowed.
  • Makito X ENC with FW 2.6.0-2 will make route fail if the fps that is set in the Preset is higher than the fps of the source input.
  • The bitrate reported in the Hub UI may not be accurate if the encoder bitrate changes for a running route.
  • RTMP hublet supports streams with a single audio track only.
  • Makito video preset has no validations for Max Bitrate.
  • When performing bulk operations on routes, some of the status update messages may be missed. 
  • Opening the same Makito route on multiple browser tabs simultaneously makes telemetry being displayed intermittent.
  • Notifications are sent to every user in the active Hub subscription only.
  • FEC-specific telemetry is not supported.
  • RTMP hublets in consumer mode are reported as connected irrespective of the input signal.
  • RTP output hublet status does not consider the status of the external connections.
  • Instant bitrate displayed in the topology view is not accurate for internal connections.
  • Connection state for internal connections is not correctly updated when there is no input signal.
  • Subscription selector for admins – num of routes is not updated.
  • Akamai hublet does not support 4:2:2 8 and 10bit source.
  • Akamai hublet does not support video from Makito X encoder with Intrafresh enabled.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.