Release Notes 2.2.0

Haivision Hub Release 2.2.0 Update

This latest release to Haivison Hub focuses on AKC infrastructure and configuration updates.

Agile outputs are disabled for appliance-to-appliance direct routes.
Only a single input hublet per route is allowed.
Makito X ENC with FW 2.6.0-2 will make route fail if the fps that is set in the Preset is higher than the fps of the source input.
The bitrate reported in the Hub UI may not be accurate if the encoder bitrate changes for a running route.
RTMP hublet supports streams with a single audio track only.
Makito video preset has no validations for Max Bitrate.
When performing bulk operations on routes, some of the status update messages may be missed.
Opening the same Makito route on multiple browser tabs simultaneously makes telemetry being displayed intermittent.
Notifications are sent to every user in the active Hub subscription only.
FEC-specific telemetry is not supported.
RTMP hublets in consumer mode are reported as connected irrespective of the input signal.
RTP output hublet status does not consider the status of the external connections.
Instant bitrate displayed in the topology view is not accurate for internal connections.
Connection state for internal connections is not correctly updated when there is no input signal.
Subscription selector for admins – num of routes is not updated.
Akamai hublet does not support 4:2:2 8 and 10bit source.
Akamai hublet does not support video from Makito X encoder with Intrafresh enabled.