Skip to main content

Release Notes 1.10.125

Haivision Hub Release 1.10.125 Update – May 6th, 2021

Component Versions

  • Hub: 1.10.125.a4a8b618

  • Hub API: 1.0.52

  • Admin App: 1.0.7

This latest release to Haivision Hub introduces:

  • Support for the Makito X/X4 Encoders:
    • Pairing of Makito X/X4 encoders with Hub for device control and status monitoring.
    • Streaming from Makito X/X4 encoders to Hub routing workflows through the Makito Hublet.
    • Preset creation for Makito X/X4 video and audio encoders to streamline configuration in routing workflows.
  • Release of the Real-Time transcoder (RTT) Process Hublet.
  • Introduction of new route orchestrator and infrastructure components allowing for significantly reduced and more predictable route start times. NOTE: Existing customers will be contacted by support prior to enabling the new components.

Bug Fixes

  • Editing of Akamai and RTT Hublet Presets no longer requires updating of the routes in which the preset is used.
  • Minor UI updates and bug fixing, including:
    • Makito Preset Creator: "Partitioning" checkbox now remains selected.
    • RTT Processing Hublet: 50 fps is now available for preset.
    • Makito Hublet: Field naming is now consistent with the Preset Creator.
    • Preset Creator: Partitioning and Intra Refresh are no longer "disabled" after saving a preset with both enabled.

Known Limitations

  • The new version of the route orchestrator does not support the following route topologies. Customers who have not migrated to the new orchestrator will not be impacted:
    • RTMP Hublet connected to a RTT Hublet.
    • RTMP Hublet connected to an Akamai Hublet if both are in the same region.
  • Makito video preset has no validations for max bitrate. This means that customers must ensure not to configure a bitrate value that is unsupported by their hardware.
  • When performing bulk operations on routes, some of the status update messages may be missed. 
  • RTT presets can be deleted only if not in use.
  • Makito preset creator: Entropy Coding (CAVLC) & Partitioning and Intra Refresh (disabled) revert to default value. 
  • Makito preset creator: Intra-Refresh with I-frame GOP is available, but not a valid configuration for Makito X/X4 devices. Configuring this combination will cause the route to fail to provision.
  • Opening the same route with a Makito Hublet on multiple browser tabs simultaneously makes the telemetry being displayed intermittent.
  • Bulk actions on notifications have been disabled due to an issue that has been detected. These will be re-enabled in an upcoming release.
  • Notifications are sent to every user in the active Hub subscription only.
  • The message, "Page cannot be found", is displayed briefly when an Admin approves a new user joining the Hub subscription.

  • RTP FEC-specific telemetry is not supported.

  • RTP status is not correctly updated to reflect streaming status.

  • TS over UDP Hublets report status connected irrespective of the input signal.

  • Routes in Stopping/Incomplete state can only be stopped individually.

  • Instant bitrate displayed in the topology view is not accurate for internal connections.

  • Connection state for internal connections is not correctly updated when there is no input signal.
  • SRT output Hublet connection state does not return to connecting when there is no input signal.
  • Subscription selector for admins – number of routes is not updated.

API Release: 1.0.52.0

What’s new:

  • SystemParameters added to the Hublet Definition. SystemParameters will be refreshed each time Hublet Definition is loaded.
JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.