Skip to main content

Section 1 Route Information

Creating a Channel
StepDescription
1Name and Description
2Source
3Protocol Settings (SRT only)
4Destinations

The following figure shows the Route Information section of the Route screen. The numbered callouts in the figure indicate the step number in this procedure.

  1. Enter the desired name for the route.
  2. Select whether to automatically start the route after it is created.

    Tip

    If this checkbox is disabled, when subsequently starting the route, its destinations must be manually started.

Continue to Section 2 Source.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.