Skip to main content

Configuring the Time and Date

To configure the time and date from the Unit Panel or from the Web Interface, see the tabs below.

Unit Panel
  1. From the Home menu, tap
    Settings icon
    >
    Settings icon
     > General > Date
    .
  2. (Optional) Enable the Use NTP toggle and enter an NTP Server address in the field below.

    Tip

    After entering the address of the NTP server you wish to use, tap the Test button to ensure you can connect to it.

  3. Set the date and time and tap

    Check icon
    to confirm.

    Note

    The Date and Time format is set to: YYYY-MM-DD HH:MM,

Web Interface

Set Date & Time Manually

  1. In the sidebar, click Settings > System.
  2. Ensure the Use NTP toggle is disabled.
    Disable NTP
  3. Click within the Manually Set Date & Time field.
    A calendar and clock dialog appears for you to select the date and time:
    Calendar and Clock
  4. Click Apply in the dialog.
  5. Click the Apply button.

Set Date & Time via NTP Server

  1. In the sidebar, click Settings > System.
  2. Click the Use NTP toggle button to enable NTP server.
  3. Enter a valid NTP Server address in the available field.

    Tip

    After entering the address you wish to use, click the Test button to ensure you can connect to it.

    Enable NTP

  4. Select the desired Time Zone from the drop-down list.
  5. Click the Apply button.

Note

The device reboots after you change the NTP settings.


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.